Owners manual

Position and bolt Retrax rails to mounting blocks. Center the threaded holes in the mounting blocks
behind the openings of the Retrax rail. Start 1/4”-
28 x 1” bolt and flat washer in all 6 holes.
Tighten bolts using 1/2” wrench.
STEP 8
Go to Step 9 in the instructions.
In Step 10 the .050 spacers can be used to narrow the distance between the rails
if needed to get the rails parallel to each other.
Position the spacers between the back of the RETRAX and the mounting block.
NOTE: Due to the unique configuration of the Dodge RamBox rails and toolboxes,
it is not possible to completely seal the bed with a bed cover.
18” of 1/2” thick self adhesive weather-strip has been provided that can be
applied where desired at the owner’s / installer’s discretion
ASSEMBLY AND INSTALLATION INSTRUCTIONS