Owners manual

Parts checklist for large box
Instruction packet with 1 roll 3/8” foam
Cover rolled into canister-spiral assembly
Front cover for canister
(*except for Tacoma 5’ models)
*
Tacoma 5’ Models - front cover is shipped in 3rd box
Drain tube kit - Keys
Parts checklist for rail box
Driver side rail
Passenger side rail
Clamp box including:
(4) Rail to Canister mounting screws
10-32 x 7/16” Stainless Phillips head
(2) Front Cover mounting screws
10-24 x 3/4” Black Stainless Allen head
(4) Rail Mount Assemblies
Each assembly includes:
(1) 1/2” thick spacer block - 5’ models
or 1- 1/4 ” spacer block - 6’ models
(1) 3/8 - 16 x 1-1/2” bolt - 5’ models
or 3/8 - 16 x 2 - 1/4” bolt - 6’ models
(1) rail cleat
(1) 3/8” washer
(8) Rubber adjustment spacers
(1) 1/8” measuring tool
(1) 1/8” Allen wrench
Tools Needed
#2 Philips screwdriver
9/16” wrench (ratchet works best)
DO NOT USE LOCTITE!
USE OF LOCTITE VOIDS WARRANTY
Pre-assembly guidelines
Two or more people are recommended for installation and you should allow 1 to 1 ½ hours to complete.
Floor space about the size of pickup box is needed for assembly of the bed cover and rails.
Clear out the pickup box and clean the front and side bed rails.
Drain tubes
(2) 1/2" drain tubes connect to the bottom of canister and can exit out the floor or front of the pickup bed.
If needed a 1/2" hole can be drilled into both front corners of the box. The bed is composite and will not rust.
If you have any questions or concerns please call 800-206-4070 or e-mail [e-mail]
Thank you for your purchase of the RETRAX™ bed cover system.
Please read and follow instructions before un-boxing and assembling the bed cover.
Check for shipping damage.
Keep boxes and packing until installation is complete.
Unpack carefully to prevent scratching.
Remove protective films from cover and canister after installation is complete.
Remove the protective plastic films before exposing to direct sunlight.
Do Not lubricate RETRAX—See Maintenance page for proper care.
ASSEMBLY AND INSTALLATION INSTRUCTIONS