Installation Manual

For proper cover operation, ensure rails are
positioned correctly (must be parallel). See
step 6 & 7 in standard instructions).

 



 
RED
POSITIVEBROWN 
NEGATIVE 
STEP 5: Connect the wiring harness to electronics box and battery
NOTE: RETRAX



Operation of the POWERTRAX





These surfaces must be level
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For proper cover operation, ensure rails are
positioned correctly (must be parallel). See
step 6 & 7 in standard instructions).

 
 

 

RED
POSITIVE BROWN 
NEGATIVE 
STEP 5: Connect the wiring harness to electronics box and battery
NOTE: RETRAX   
 
 

Operation of the POWERTRAX





These surfaces must be level
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inter-
ference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Proceed with the RETRAX standard instructions steps 1-8. Then refer back
to this page for connection wiring. Disregard all references to 'lock'- Not applicable for POWERTRAX.
NOTE: The electric cover has no lock assembly. Cover will not move out of the canister at this point of installation.
PowerTrax Installation
0