Owners manual

STEP 3 Install the drivers rail. Pull the cover out of the canister 6”-8” (See PowertraxONE
Installation Supplement on how to move electric cover). Caution: DO NOT allow cover to roll
back into canister until rail is installed. Repeat Step #2 to install the driver's rail.
Be sure all rail mounting screws are tight.
Slide the rail over the
cover until the two
threaded holes in the
rail are lined up behind
the two holes in the
spiral. Attach using two
of the 10/32 by 7/16"
screws. Tighten using
a manual #2 Phillips
screwdriver.
DO NOT USE LOCTITE!
USE OF LOCTITE VOIDS WARRANTY
STEP 4 Install the front
cover.
The front cover is
attached below the rails.
Hold the cover level and push
both ends in evenly to help
slide it into place. When the
holes are lined up, start
threading the (2) Front Cover
mounting screws Tighten the
2 screws securely using the
enclosed 1/8” Allen wrench.
STEP 2 continued.
SIDE VIEW OF FRONT COVER
This end towards tailgate
Weather-strip towards cab
Front Cover
ASSEMBLY AND INSTALLATION INSTRUCTIONS