Instructions / Assembly

19
Ensure both Lateral Insect Screen Side Tracks (J) are ALIGNED. See
Figure 2.2.1A
Lateral Insect Screen Side Tracks (J) are about 65 inches long. The
black brushweatherstrip at about 63 inches long, is SHORTER than the
Lateral Insect Screen Side Track (J) because in addition to the black
brushweatherstrip, the Lateral Insect Screen Track (J) must ALSO
accommodate a Lateral Track Insect Screen Stopper (L).
Ensure that the black brushweatherstrips inside the Lateral Insect
Screen Track (J) are all 4 aligned at one end, leaving the other end of
the Lateral Insect Screen Track without any brushweatherstrips for the
last approximately 2 inches (5 cm.) of the Lateral Insect Screen Track
(J). See Figure 2.2.1B. (Those last 2 inches will accomodate the Lateral
Insect Screen Stoppers (L) inserted by you in Step 2.4.3. below) The side
of the Lateral Insect Screen Tracks (J) that has NO brushweatherstrip will
become the bottom of the retractable insect screen frame and rest on your
window sill when the installation is complete.
2.2.2. Unroll the enclosed paper Measuring Tape (K) and place its 67 inch
mark at the top extremity of the Lateral Insect
Screen Track (J) WITH the black brushweatherstrip. (See Figure 2.2.2A,
and right side of Figure 2.2.2B)
Fold the remaining 1/4 inch of tape so it falls down the top extremity side of
Lateral Insect Screen Track (J). See Figure 2.2.1B.
Unica A-7 Modification: USE this modification ONLY for Model Unica
A-7.
For model Unica A-7 which is only 52 inches long, unroll the enclosed
paper Measuring Tape (K) and place tape (K) with its 52 inch mark at
the top extremity of the Lateral Insect Screen Track (J) WITH the black
brushweatherstrip.
Fold the remaining 10 and 1/4 inch of tape (K) so it falls down the top
extremity side of Lateral Insect Screen Track (J)
as shown in Figure 2.2.2B.
2.2.3. Retrieve the measurement you recorded in Box H in Step 2.1 above;
as Inside Side Jamb Height (window opening height) = H inches. MARK
the enclosed Measuring Tape (K) at “H inches” (the window opening
height measurement determined in Step 2.1. above). At this point the
Measuring Tape (K) should be still unrolled atop Lateral Insect Screen
Tracks (J) so you can mark the cutting point on Measuring Tape K, and then
transcribe/mark the cutting point on the Lateral Insect Screen Tracks (J) so
you can cut at Mark “H” inches ON the Lateral Insect Screen Tracks
(J).
2.2.4. CUT both Lateral Insect Screen Tracks (J and J) at the same time,
at the “H inches” height you determined in Step 2.1. as the INSIDE SIDE
JAMB HEIGHT (window opening HEIGHT). (See Figure 2.2.4.)
Figure 2.2.1A
Figure 2.2.1B
Figure 2.2.2A Figure 2.2.2B
I
M
P
O
R
T
A
N
T
I
M
P
O
R
T
A
N
T
!
MARK
CUT
Figure 2.2.4