Installation Guide

7
VI. ASSEMBLY & INSTALLATION OVERVIEW
In order to install this Retractable Insect Screen for your Window you execute 3
main steps:
1
2
3
PLEASE READ the detailed INSTRUCTIONS in this Installation Guide
COMPLETELY BEFORE INSTALLATION and if possible VIEW the 10 Minute
INSTALLATION VIDEO at https://youtu.be/3v0fAe30kJQ
We user tested the Installation Guide and designed Instructions so
as to maximize the ease of installation, please READ INSTRUCTIONS
COMPLETELY.
MEASURE AND CUT THE MOSQUITO SCREEN HEADER
Measure the width of window opening HORIZONTALLY; also known as the
window's HEAD JAMB width.
Cut the Mosquito Screen Header (A) as per DETAILED
Step 1 instructions in Section VIII of this Installation Guide (NOTE that
allocations for WIDTH of Header End Caps ( I ) and (E) is pre-calculated
into the Measuring Tape Template (N) ADHERED to the top of Screen
Cartridge Header (A).)
MEASURE AND CUT the LATERAL SIDE TRACKS
Measure the length of the window opening VERTICALLY; also known as
the window's JAMB (Side Jamb) length.
Cut Lateral Insect Screen Tracks (J) as per DETAILED
Step 2 instructions in Section VIII of this Installation Guide.
(NOTE that allocations for the LENGTH of Head Screen Cartridge (A) is
pre-calculated into enclosed Paper Measuring Tape (K).)
AFFIX HEADER (A) and LATERAL TRACKS (J) into WINDOW
Using enclosed screws affix Retractable Insect Screen to sides of your
window opening.
The parts of a window you will need to know are illustrated in
Figure: Parts of a Window. Identify your Window's; HEAD
JAMB, JAMB (Side Jamb) and SILL
Figure: PARTS OF A WINDOW
VII. QUICK START GUIDE (For experienced handyperson)
The Quick Install Guide is intended as overview for experienced handypersons.
Please see Section VIII ‘s DETAILED INSTRUCTIONS for more thorough installation detail.
STEP 1: MEASURING AND PREPARING THE MOSQUITO SCREEN
HEADER
STEP 1.1. Measure the width the INSIDE HEAD JAMB
Use your household tape to Measure the width of the inside jamb of your
window at the Head Jamb level. See Figure 1A and 1B.
Record the measurement you took in Step 1.1. as the window Head Jamb
opening width = W inches.
The measurement you note (W inches) will be used as a reference of
where to cut when cutting the Screen Cartridge Header and Pull Bar
(A1/A2).
Write the window's Head Jamb opening WIDTH measurement in
Box W to the right for easy reference.
Figure 1A
Figure 1B
BOX W
Cut at “W” =
MEASURE