Installation Guide

4
III. PARTS IDENTIFICATION
VERIFY THAT PARTS A (A1/A2) and J (pictured in Figure: PARTS of
Retractable Insect Screen)
are in your kit.
Please note that A1 (Screen Cartridge Header) & A2 (Pull Bar) are ONE
PIECE, already Factory assembled together.
The Screen Cartridge Header & Pull Bar (A (A1/A2)) are identified as A1
and A2 in order to make instructions easier to follow. But A1 and A2 are
NOT separate parts they (A1 & A2) are ONE SINGLE UNIT (A) or one
pre-assembled part.
A2 (the Pull Bar) has already been FACTORY INSTALLED into A1 (The
Screen Cartridge Header).
The 2 main different components of Part A; A1 and A2 are identified as A1
and A2 in instruction illustrations merely to make installation instructions of
RetractableBugScreen TM
easier to understand and successfully follow.
Please note that an Existing Permanent End Cap (O) has been Factory
Installed on the RIGHT side of the A1 component of Screen Cartridge
Header (A). “O” is NOT a separate part.
Part “O” is identified in the Parts and Hardware List in Section II and in
Figure: Existing Permanent End Cap, because it important to know where
the Existing Permanent End Cap (O) is, as it (O) must
NOT be removed or tampered with in any way. The Existing Permanent
End Cap (O) is precisely machine torsioned and tampering or removing the
Existing Permanent End Cap (O) will break the unit.
I
M
P
O
R
T
A
N
T
I
M
P
O
R
T
A
N
T
!
J
L
A1
A2
O
A1&A2
N
Glued Measuring Tape Template
Figure: PARTS of RetractableBugScreen TM
TOP (When installed will fit into window's Head Jamb)
BOTTOM (When installed will rest on window Sill)
Figure: Existing Permanent End Cap “O”
(Not a separate part; part O is factory installed).
LEFT Side
RIGHT Side
IV. HARDWARE COMPONENTS & REFERENCE TOOL IDENTIFICATION
VERIFY THAT PARTS B, C, D, E, F, G, H, I, K, L and M (pictured in Figure:
HARDWARE) ARE ALL THERE*
Please note that a Measuring Tape Template is factory glued to the top
side of Screen Cartridge Header A(A1/A2). This Glued Measuring Tape
Template is referred to as component “N” in the Instruction Guide, so as to
facilitate following Installation Guide instructions.
(Not a separate part;
part N is factory glued/installed).
*If you lose or misplace any of the component parts during installation NO
WORRIES please contact our customer care service team at
[e-mail] or call us at 1-407-450-5134
and we will be happy to send you duplicate hardware components.
Figure: HARDWARE*