Operating instructions

Settings

Call-back code ...................... Here, you enter the call-back code of your telecom-

munications provider (as for the Deutsche Telekom,

this is H*37#). The “H” stands for the hook flash-

function. Up to 6 digits are at your disposal for en-

tries.

hold ......................................... Off or 1-8. This function allows you to set an outgoing

message which can be played back during a tele-

phone conversation on pressing one key (hold-

OGM).

Telephone systems/PABXs .. >>

Trunk access code .... Here, you enter the code to access the public ex-

change time (e. g. 0). This number will then always

be dialled automatically before the telephone number

apart from cases where a telephone number is

marked by “i” which stands for an internal extension

of the telephone system.

CLIP correction .......... Some telephone systems insert digits before the

transferred caller's telephone number. This leads to

wrong numbers being displayed. In order to identify

the digits “added” and to eliminate those, you can

enter the numbers in questions here.

Internal call-back

code (CCBS) .............. Here, you can enter the call-back code of your tele-

phone system (e. g. 79). Up to 6 digits are available

for your entry.

Dialling mode ............. DTMF (dual tone multi frequency also known as tone

dialling) or the pulse dialling method. If your tele-

phone access does not support the customary tone

dialling method yet, you have the option to switch to

the old pulse dialling method.

Special information tone ...... You can either set the information tone volume to

level 1 to 4 or you can set it OFF. If you activate the

information tone by setting the volume, a new in-

coming message will be indicated by an information

tone given every 10 seconds.

Display light ........................... Automatically or ON. As for the parameter “automa-

tically”, the display will no longer be lit after 10 sec-

onds. Should the display be lit permanently, select

“ON” here.