& Keys to a SUCCESSFUL Application ®
Application Tips • Remove Old Paint or Stain From the Surface – Use a deck stripper or 50 grit sandpaper to remove old finishes/coatings. Then conduct the splash test to ensure surface is ready for Restore. • Check the Weather Report – The temperature cannot fall below 50ºF during application and for at least 72 hours after application. If applied below 50ºF or if temperature falls below 50ºF within 72 hours after application, the product will not adhere to the surface.
WHERE TO APPLY HORIZONTAL • Horizontal, structurally sound SURFACE wood and composite surfaces. • Aged Wood: Make sure to properly prepare the surface per the instructions below. • New wood: Should age for a minimum of 6 months before application. The lumber must dry completely before applying the product to prevent peeling of the coating. • Composite: Some composite decking is engineered with moisture repellent or sealer that may prevent proper adhesion.
HOW TO PREPARE THE SURFACE • PERFORM LIGHT REPAIRS – Raised nail heads and/or screws should be secured before application. Remove loose splinters and replace severely damaged or rotting boards. Fill larger cracks using Restore Crack Filler or similar acrylic, non-silicone filler. Allow to dry. • CLEAN THE SURFACE – Loose paint needs to be scraped then sanded. Use a brush and the Restore Deck & Concrete Cleaner.
HOW TO APPLY APPLY TWO THICK COATS OF DECK & CONCRETE RESTORE 10X • The first coat fills in cracks and makes minor repairs. It soaks into the wood and dries. This coat may be blotchy and spotty. • The second coat works as a finishing coat and provides protection against future wear of the surface. • Apply thick coats. MAINTAIN AN EVEN TEXTURE Work in small areas and roll in one direction only. Do not overwork the coating by rolling back and forth with the roller in the same spot.
DECK & CONCRETE RESTORE® 10X is a tough, durable coating formulated to extend the life of decks and patios, saving the cost of replacement. It is ten times thicker than ordinary paints and stains. FOR DECKS: For horizontal wood and most composite decks. New wood decks need to age at least six months before application. Follow specific manufacturer’s recommendation before applying to any composite decking. FOR CONCRETE: For use on broom swept or porous concrete surfaces.
