Night Stand Contains One (1) Night Stand and Hardware IMPORTANT NOTE: Carefully remove all the parts from the box, Arrange on a flat TOOLS REQUIRED: surface and verify you have all of the following parts and hardware Phillips Screwdriver 1.Top Panel (1 PC) 2.Shelf Panel (1 PC) 3.Bottom Panel (1 PCS) 4.Side Panel L/R (2 PCS) 5.Back Panel (1 PC) 6.Legs (4 PC) Ae HARDWARE LIST Allegheny (PCS) ~~ B.Dowel (12 PCS) CBC W 40mm (4 PCS) D. Minifix Bolt Feminine House ( PC) F. Minifix Cap (8 PC) G.
ASSEMBLY INSTRUCTIONS STEP 1 Tap Dowels (B} into the Left and Right Side Panels (Part 4) and into the Shelf Panel (Part 2) in the larger holes provided. STEP 2 Using a Phillips Head Screwdriver, attach Mini fix Bolts (D) to the Top Panel (Part 1) and the Left and Right Side Panels (Part 4) as indicated.
ASSEMBLY INSTRUCTIONS STEP 3 Insert Mini fix House (Part E) into the Left and Right Side Panels (Part 4) and the Shelf Panel (Part 2) as Attach the Right Side Panel (Part 4) to the STEP 4 Shelf Panel (Part 2) as shown. Turn the Mini fix House (E) to tighten using the Allen Key. Cover the Mini fix House using the Mini fix Cap (F) by pressing it into the Mini fix House. This is how a mini fix works... The head of the mini fix 2 using goes into the open y mouth of the mini fix bolt.
ASSEMBLY INSTRUCTIONS Attach the Left Side Panel (Part 4) to the Shelf Panel (Part 2) as shown. Turn the Mini fix House (E) to tighten using the Allen Key. Cover the Mini fix House using the Mini fix Cap (F) by pressing it into the Mini fix House. This is how a mini fix works... The head of the mini fix ar housing goes into the open mouth of the mini fix bolt. You then tum the mini fix housing so it tightens over the mini fix bolt. *Attach Mini fix Cap as shown.
ASSEMBLY INSTRUCTIONS STEP 7 Insert the Back Panel (Part 5) into the back of the nightstand by sliding h the Back panel into the slots provided. BACK VIEW STEP 8 Attached the Bottom Panel (Part 3) to the bottom of the Nightstand using 4 CBC W 40mm screws. Tighten using Allen Key (A).
ASSEMBLY INSTRUCTIONS STEP 9 Attach the Mounting Legs H) to the Bottom Panel (Part 3) in the holes provided using 16 20mm Screws (G) and a Phillips Head Screwdriver. Secure the Mounting Legs tightly. Attach the 4 Legs (Part 6) to the Mounting legs by turning the legs clockwise until fully tightened. STEP 10 Attach the L Bracket (I) to the back of the nightstand using 16mm Screws (J) and a Phillips Head Screwdriver as shown.
