Night Stand Contains One (1) Night Stand and Hardware IMPORTANT NOTE: Carefully remove all the parts from the box, Arrange on a flat TOOLS REQUIRED: surface and verify you have all of the following parts and hardware Phillips Screwdriver 1.Top Panel (1 PC) 2 Middle Panel (1 PC) 3 Left Leg Panel (4 PCS) 4.Right Leg Panel (4 PCS) 5.Short Apron (4 PCS) 6.Long Apron (4 PCS) HARDWARE LIST A.Allen Key (1 PC) B. Minifix Bolt (24 PCS) C Mini fix House (24 PCS) D.Screw 30mm (16 PC) E.White Nail (8 PCS) F.
ASSEMBLY INSTRUCTIONS Using a Phillips Head Screwdriver, attach Mini fix Bolts (Part B) to the Top Panel (Part 1) and Left and Right Leg Panels (Parts 3 and 4) as indicated. STEP 2 To how a min Attach the Left legs (Part 3) to the me hh nine Right legs (Part 4) as shown. Turn #7 Imibgpeimiion | the Mini fix House (Part C) to C, raguonugnms | tighten using the Allen Key.
ASSEMBLY INSTRUCTIONS STEP 3 This is how a mini fix works... 1 The head of the mini fix 5% housing goes into the open ‘mouth of the mini fix bolt. You then turn the mini fix Si, housing so it tightens i over the mini fix bolt. Attach the the legs to Middle Panel (Part 2) as shown. Turn the Mini fix House (Part C) to tighten using the Allen Key. Cover the Mini fix House using the Mini fix Cap (Part F) by pressing it into the Mini fix House.Repeat the step 4 times. *Attach Mini fix Cap as shown.
Attach the short and long Apron (Part 5,6) and tighten using screw 30mm (Part D). Attach the White Nail (Part E) to the legs by either pushing them in with your hand or using a mallet/hammer.
