Use and Care Manual
A. Arm (2 pcs) B. Back Panel (1 pc) C. Roll Out Slats (1 pc)
A1
A2
G.
Trundle Back Panel (1 pc)
I. Trundle Slats (1 pc) J. Wooden Block (4 pcs)
D. Front Side Panel (1 pc)
E. Back Side Panel (1 pc)
H. Trundle Side Panel (2 pcs)
IMPORTANT NOTE:
Carefully remove all the parts from the box. Arrange on a at
surface and verify you have all of the following parts and hardware.
PARTS LIST
HARDWARE LIST
(Continued on back)
STEP 1
STEP 3
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
Phillips Screwdriver
A A
Attach the Front Side Panel (Part D) and the Back Side Panel (Part E) to the Arms (Part A1 & A2) as shown.
Attach the Back Panel (Part B) to the Arms using four 50mm Bolts
(Part K), four Spring Washers (Part N), four Flat Washers (Part O)
and Small Hex Key (Part M).
Place the Roll Out Slats (Part C) on the runner boards of the siderails.
Tighten the side panels to the arms using Large Hex Key (Part L).
Secure the slats to the side panels using twelve 32mm Screws (Part P)
in the holes that are circled.
K. 50mm Bolt
(8 pcs)
L. Large Hex Key
(1 pc)
M. Small Hex Key
(1 pc)
Q. 16mm Screw
(24 pcs)
O. Flat Washer
(4 pcs)
P. 32mm Screw
(64 pcs)
N. Spring Washer
(4 pcs)
F. Trundle Front Panel (1 pc)
R. Roller
(6 pcs)
P
C
C
L
STEP 2
D
E
A2
A1
The holes on the slats that are circled
must be secured with screws. All other
holes are optional to secure with screws.
B
A2
A1
N
K
O
M