Use and Care Manual

Assembly Instructions

Contains One Bed and Hardware

STEP 4

STEP 6

STEP 5

STEP 7

ASSEMBLY INSTRUCTIONS (CONTINUED)

A A

Align the Rollers (Part R) to the Trundle Slats (Part I) as shown.

Be sure to align the rollers with the marking on the slats. Secure

the roller using four 16mm Screws (Part Q) for each roller.

Attach Trundle Front Panel (Part F) and Trundle Back Panel (Part G)

to Trundle Side Panel (Part H) as shown.

Place the Wooden Blocks (Part J) under the trundle side panels to

make attaching the slats easier. Place the Trundle Slats (Part I) on the

runner boards of the trundle front and back panels. Tighten the front

and back panels to the side panels using Large Hex Key (Part L).

Tighten the slats using 20 of the 32mm screws (Part P) in the holes

that are circled. Remove the wooden blocks.

Your Day Bed is now ready for use.

The holes on the slats that are circled

must be secured with screws. All other

holes are optional to secure with screws.

x20

PAGE 1
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 4 STEP 5 Assembly Instructions R Contains One Bed and Hardware Q G H I F H Attach Trundle Front Panel (Part F) and Trundle Back Panel (Part G) to Trundle Side Panel (Part H) as shown. Align the Rollers (Part R) to the Trundle Slats (Part I) as shown. Be sure to align the rollers with the marking on the slats. Secure the roller using four 16mm Screws (Part Q) for each roller.
PAGE 2
IMPORTANT NOTE: ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: Carefully remove all the parts from the box. Arrange on a flat surface and verify you have all of the following parts and hardware. Phillips Screwdriver STEP 1 PARTS LIST A. Arm (2 pcs) B. Back Panel (1 pc) C. Roll Out Slats (1 pc) A2 D. Front Side Panel (1 pc) A2 E A1 D E. Back Side Panel (1 pc) F. Trundle Front Panel (1 pc) G.