Instructions / Assembly

STEP 3 STEP 4

STEP 6

ASSEMBLY INSTRUCTIONS (CONTINUED)

Attach the remaining leg (Part E) to the center

support (Part C) using two screws (Part H), two

washers (Part J) and two nuts (Part I). Tighten

using hex key (Part K) and wrench (Part L).

Put center slat holders (Part F) on one side and

side slat holders (Part G) on the other side of the

10 single slats (Part D).

Put center slat holders (Part F) on one side and

side slat holders (Part G) on the other side of the

3 double slats (Part D).

Put side slat holders (Part G) on one side of the

3 remaining double slats (Part D).

Attach the center support from Step 3 to the

frame from Step 2 using two screws (Part H), two

washers (Part J) and two nuts (Part I) per side.

Tighten using hex key (Part K) and wrench (Part L).

Attach slats to one side of the frame and center

support by pressing the pegs into the holes.

Double slats are installed in the middle.

Attach slats to the other side of the frame. Double

slats are installed in the middle. By moving the

blue sliders on the double slats closer together

you can make the middle section plusher, and by

moving them apart - make it rmer.

STEP 5

STEP 8

Put side slat holders (Part G) on one side of the

10 remaining single slats (Part D).

STEP 7