Instructions / Assembly

A. Side Rails (2 pcs)

B. Foot and Head Rails (2 pcs)

C. Center Support (1 pc)

D. Wood Slats (30 pcs)

E. Legs (8 pcs)

Platform Frame

Contains One (1) Frame and Hardware

Carefully remove all the parts from the carton. Arrange on a at

surface and verify you have all of the following parts and hardware.

PART LIST

HARDWARE LIST

(Continued on back)

J. Washer

(20 pcs)

K. Hex Key

(1 pc)

L. Wrench

(1 pc)

I. Nut

(20 pcs)

H. Screw

(20 pcs)

F. Slat Holder -

Center (15 pcs)

G. Slat Holder -

Side (30 pcs)

With holes facing up, insert the side rails

(Part A) into the foot and head rails (Part B).

Attach outer six legs (Part E) to the frame using two screws

(Part H), two washers (Part J) and two nuts (Part I) per leg.

Tighten using hex key (Part K) and wrench (Part L).

IMPORTANT NOTE:

Two wooden replacement slats have been

included with this frame. Do not throw them

away. Store these replacement slats in a safe

place for future use, if needed.

QN SIZE

ASSEMBLY INSTRUCTIONS

http://www.youtube.com/watch?v=2THFfPzzpG4

VIDEO

Scan the QR code on your smart phone or device, or enter the link below to watch a

complete video of the easy assembly of the Platform Frame.

STEP 1

STEP 2

PAGE 1
Platform Frame QN SIZE Contains One (1) Frame and Hardware IMPORTANT NOTE: Two wooden replacement slats have been included with this frame. Do not throw them away. Store these replacement slats in a safe place for future use, if needed. Carefully remove all the parts from the carton. Arrange on a flat surface and verify you have all of the following parts and hardware. PART LIST A. Side Rails (2 pcs) D. Wood Slats (30 pcs) F. Slat Holder Center (15 pcs) E. Legs (8 pcs) G.
PAGE 2
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 3 Attach two remaining legs (Part E) to the center support (Part C) using two screws (Part H), two washers (Part J) and two nuts (Part I) per leg. Tighten using hex key (Part K) and wrench (Part L). STEP 5 STEP 4 Attach the center support from Step 3 to the frame from Step 2 using two screws (Part H), two washers (Part J) and two nuts (Part I) per side. Tighten using hex key (Part K) and wrench (Part L).