Instructions / Assembly

Lay the platform frame (part A) at on the oor

with the legs facing up (both halves).

STEP 1

STEP 2

HARDWARE LIST

A. Platform Frame (2 pcs) B. Wide End Arch Leg (2 pcs)

D. Support Brackets (3 pcs)

C. Narrow End Arch Leg (2 pcs)

E. 2

" Bolt

(2 pcs)

F. Rubber Spacer

(2 pcs)

G. Wing Nut

(2 pcs)

H. 1" x

” Bolt

(10 pcs)

I. 1" x

” Bolt

(12 pcs)

Arch Platform Frame

Contains One (1) Frame and Hardware

IMPORTANT NOTE:

Carefully remove all the parts from the carton. Arrange on a at

surface and verify you have all of the following parts and hardware.

PART LIST

TOOLS REQUIRED:

Phillips Screwdriver

ASSEMBLY INSTRUCTIONS

(Continued on back)

DB, QN, EK, CK SIZES

Rotate the leg supports into position against

the pre-attached bolts and secure them in

place by rmly tightening the pre-installed

wing nuts.

PAGE 1
Arch Platform Frame DB, QN, EK, CK SIZES Contains One (1) Frame and Hardware IMPORTANT NOTE: TOOLS REQUIRED: Carefully remove all the parts from the carton. Arrange on a flat surface and verify you have all of the following parts and hardware. Phillips Screwdriver PART LIST A. Platform Frame (2 pcs) C. Narrow End Arch Leg (2 pcs) B. Wide End Arch Leg (2 pcs) D. Support Brackets (3 pcs) HARDWARE LIST E. 21/4" Bolt (2 pcs) F. Rubber Spacer (2 pcs) G. Wing Nut (2 pcs) H.
PAGE 2
ASSEMBLY INSTRUCTIONS (CONTINUED) STEP 3 STEP 4 D F G E I I HALF 1 HALF 2 Connect the two platform frame halves (part A) using two of the 21/4" bolts (part E) and two rubber spacers (part F). Secure the bolts in place using the two wing nuts (part G). Install the three center support brackets (part D) to the legs of the platform frame (part A) using the 1" x 1/4" bolts (part I). Secure the bolts tightly. Note: there are a total of 12 bolts needed for the three support brackets.