Specifications

16
ROUTINE USE
Connecting
the Circuit
1. Connect the circuit. Before each use, examine the flexible tubing
for any damage or debris. If necessary, clean the
tubing to remove the debris. Replace any damaged tubing.
a. Connect the mask to the headgear, following the instructions
included with the headgear. Press the Pressure On/Off button
on the top of the Solo to turn the air flow ON.
b.Put on the mask and headgear, and breathe normally
through your nose.
Adjusting
the Circuit
2. Adjust the circuit.
a. Lie down on your bed and adjust the flexible tubing so it is
free to move if you turn in your sleep.
b.Adjust the mask and headgear until you have a comfortable fit
and there are no air flow leaks into your eyes.
When the air flow is on, the green signal light will go out.
Pressure
On / Off Button