Specifications

The water chamber should be cleaned daily or after each use.

WARNING! Emptying and cleaning the water chamber daily will help to

prevent mold and bacteria growth.

WARNING! Allow the water in the chamber to cool down to room tempera-

ture before removing it from the humidifier.

WARNING! To avoid electrical shock, disconnect the power cord and power

jumper cord before cleaning the humidifier platform. DO NOT

immerse the humidifier platform or power jumper cord into any

fluids.

Water Chamber

1. Turn the CPAP device off and allow approximately 15 minutes for the heater

plate and water to cool.

2. Disconnect the tubing from the water chamber. Press down on the water

chamber and slide it out of the humidifier platform.

3. Discard any remaining water. Remove the rubber

connector from the air inlet. Gently remove the base

of the chamber with your hands being careful not to

damage the rubber seal. Wash all parts in the dish-

washer or a solution of warm water and a mild

dishwashing detergent. Rinse with clean water and

allow to air dry.

4. Reassemble and fill the water chamber. Inspect the water chamber for any

leaks or damage. Replace the water chamber if any damage is present.

Humidifier Platform

1. Clean the humidifier platform by wiping with a damp cloth. Allow to air dry.

2. Inspect the humidifier platform and power jumper cord for any damage and

replace if necessary.

SERVICE

The humidifier does not require routine servicing.

If the humidifier malfunctions or if the LED starts flashing, contact your

home care provider immediately. Never attempt to open the humidifier’s

enclosure.

CLEANING