Specifications

9
1. Verify the voltage selection. Make sure the voltage selector switch
on the back of the unit is set correctly (e.g., United States and
Canada: 115V).
Note: If you change the voltage setting for travel, the fuses must
also be changed.
FIRST TIME SETUP
Checking
the Voltage
2. Install the filters in the back of the REMstar LX.
The pollen filter must be in place at all times when the REMstar LX is
operating. The white ultra-fine filter is optional and can be used in
addition to the pollen filter. The ultra-fine filter is recommended for
people who are sensitive to tobacco smoke or other small particles.
a. Place one of the pollen filters over the ultra-fine filter. Or, if you
are not using the ultra-fine filter, simply place the pollen filter into
the filter area on the back of the REMstar LX. An extra pollen filter
is included for your convenience.
b. Attach the filter cap. Position the opening on the side of the cap so
that it is facing away from the bedside. Insert the cap’s bottom tabs
into the openings below the filter area. Press down on the cap’s top
tabs and insert them into the openings above the filter area.
Installing
the Filters
AC Voltage
Selector