Specifications

FIRST TIME SETUP

WARNING!

Do not use the REMstar LX CPAP System until an appropriate

professional adjusts the settings!

To use the system, you may need the following accessories in order to

assemble the circuit. Contact your home care provider to order these

accessories. These items are not packaged with some of the Systems

because of the multiple sizes and types available.

• Flexible Tubing -Respironics 6 ft. (1.83 m) flexible tubing with a

smooth inner lumen and a 22 mm inner diameter

• Exhalation Port (e.g., Whisper Swivel

II or equivalent)

Note: This is not required if you are using a mask

with a built-in exhalation port.

• Headgear

• Nasal Mask or other equivalent interface

To determine which circuit accessories are best for you, consult with

your doctor or home care provider.

If the REMstar LX has been exposed to either very hot or very cold

temperatures, allow it to adjust to room temperature (approximately

2 hours) before beginning setup.

When operating the REMstar LX System, make sure bedclothes,

curtains, or other items are not blocking the filter cap openings or the

vents on the REMstar LX. Make sure the REMstar LX is away from

heating equipment (e.g., forced air vents, radiators).

Large elevation changes will affect the pressure being delivered

by the REMstar LX. Refer to the ”Traveling with the System”

section if you relocate or travel to areas with a significantly higher or

lower elevation.

CAUTION!

IMPORTANT!