Specifications

15
ROUTINE USE
Connecting
the Circuit
1. Connect the circuit. Before each use, examine the flexible tubing for any
damage or debris. If necessary, clean the tubing to remove the debris.
Replace any damaged tubing.
a.Connect the mask to the headgear, following the instructions included
with the headgear. Press the Pressure On/Off button on the top of the
REMstar LX to turn the air flow ON.
When the Pressure
On/Off button is
depressed, the
pressure and altitude
settings will be
displayed briefly for
you to verify.
b.Put on the mask and headgear, and breathe normally through your nose.
Adjusting
the Circuit
2. Adjust the circuit.
a.Lie down on your bed and adjust the flexible tubing so it is
free to move if you turn in your sleep.
b.Adjust the mask and headgear until you have a comfortable fit
and there are no air flow leaks into your eyes.
When the air flow is on, the green signal light will go out.
Pressure
On/Off
Button