User manual

4-8
REMSTAR PLUS M SERIES USER MANUAL
e Patient Setup screens are described below.
– FOSQ
+
Setup
1. Standby Screen
The Standby screen appears when you first apply power to the
device. You can access the Patient Setup menu from this screen by
pressing the + button. Once inside the Setup menu, press the
or buttons to cycle through the screens.
1 2 3
C-Flex Setting
FLEX comfort has been
disabled on this unit.
C-Flex Setting
2. C-Flex Setting Screen
This screen displays the C-Flex level set by your home care
provider. This setting allows you to adjust the level of air pressure
relief that you feel when you exhale during therapy. Your home
care provider will either enable, lock, or disable C-Flex.
– If C-Flex is enabled and the setting is not comfortable for you,
you can increase or decrease the setting by pressing the + or
– buttons. The setting of 1 provides a small amount of pres-
sure relief, with higher numbers providing additional relief.
Press the + or – buttons to increase or decrease the setting.
– If your provider has disabled C-Flex, you cannot enable or ad-
just the setting. The screen shown at left displays to indicate
that C-Flex is disabled.
1 2 3
Altitude
3. Altitude Setting Screen
This screen allows you to modify the altitude adjustment setting.
Press the + or – buttons to increase or decrease the setting by
increments of 1:
• 1 = less than 2500 ft. (<762 m)
• 2 = 2500 to 5000 ft. (762 m to 1524 m)
• 3 = 5001 to 7500 ft. (1525 m to 2286 m)
Note: Elevations over 7500 ft. (2286 m) may affect the accuracy
of the pressure.
Warning: If you incorrectly set the manual altitude setting, the
pressure may be too high or too low, depending on
your location.
4.0 cmH
2
O
Ramp Start Pres
4. Ramp Starting Pressure Screen
You can increase or decrease the ramp starting pressure in 0.5 cm
H
2
O increments by pressing the + or – buttons. The default setting
is 4 cm H
2
O. You can adjust the setting from 4 cm H
2
O to the CPAP
pressure setting.
Note: This screen will not display if your provider has not en
-
abled Ramp on your device.