User manual

4-1REMSTAR PLUS M SERIES USER MANUAL
CHAPTER 4: DEVICE OPERATION
is chapter explains how to start the device and change the settings.
4.1 STARTING THE DEVICE
1. Plug the device in to an AC or DC power source. e three primary buttons light up and the
Software Version screen momentarily appears, shown in Figure 4–1.
V 1.0
FIGURE 4–1 SOFTWARE VERSION SCREEN
Note: Version 1.0 shown in Figure 4–1 is an example. Your device may have a different
software version installed.
2. e next screen to appear is the Standby screen, shown in Figure 4–2. You can access the
FOSQ questionnaire or patient settings and data from this screen. See Section 4.3 for in
-
structions on how to navigate the display screens.
– FOSQ
+
Setup
FIGURE 4–2 STANDBY SCREEN
Note: The FOSQ option only appears if a SmartCard is inserted or a modem is con-
nected to the device.