User manual

3-5REMSTAR PLUS M SERIES USER MANUAL
3.4 SUPPLYING POWER TO THE DEVICE
You can power the device using AC or DC power.
Caution: If this device has been exposed to either very hot or very cold temperatures,
allow it to adjust to room temperature before beginning the following
setup procedures.
Warning: Route the wires to avoid tripping.
Warning: This device is activated when the power cord is connected. Pressing
the button turns the airflow on or off.
Important! If you are using your device with a humidifier, refer to the Quickstart
Guide included with your device or the instructions included with your
humidifier for details on how to power the device and humidifier.
3.4.1 USING AC POWER
Complete the following steps to operate the device using AC power.
1. Plug the socket end of the AC power cord into the power supply, as shown in Figure 3–5.
FIGURE 3–5 CONNECTING THE POWER CORD TO THE POWER SUPPLY
2. Plug the pronged end of the AC power cord into an electrical outlet that is not controlled by
a wall switch.
3. Plug the power supply cord’s connector into the power inlet on the back of the device, as
shown in Figure 3–6.