User manual

2-1REMSTAR PLUS M SERIES USER MANUAL

CHAPTER 2: DEVICE CONTROLS AND DISPLAYS

is chapter describes the device’s control buttons and displays, patient circuit connections, and

rear panel connections.

2.1 CONTROLS AND DISPLAYS

Figure 2–1 shows the three primary control buttons on the REMstar Plus M Series device.

C-Flex

FIGURE 2–1 PRIMARY CONTROL BUTTONS

ese buttons are described below.

BUTTON DESCRIPTION

Ramp – When the airﬂow is on, this button allows you to

activate or restart the ramp function. Ramp lowers the

airﬂow pressure and then gradually increases it, allowing

you to fall asleep more easily.

Start/Stop – This button starts the device’s airﬂow and

places the device in the Active state, or stops the airﬂow,

and places the device in Standby. You can also press this

button to exit any setting screen.

C-Flex

C-Flex – This button adjusts the C-Flex comfort setting.

If you do not want to modify the settings that your home care provider has set for you, you only

need these three buttons to start and stop therapy and do not need to use the display buttons lo-

cated under the device cover door.

Figure 2–2 shows the device display and navigation buttons that are under the cover door.

– FOSQ

Setup

FIGURE 2–2 DISPLAY BUTTONS