User manual
M Series Heated Humidier
CleanIng and servICe
CleanIng
WARNING! To avoid electrical shock, always unplug the power cord from the
wall outlet or DC power source before cleaning the humidier.
WaTer TanK
WARNING! Empty and clean the water tank daily to prevent mold and
bacteria growth.
WARNING! Allow the water in the tank to cool to room temperature before
removing the tank from the humidier.
1. Turn the therapy device off, turn the humidifier knob to 0, and allow approximately 15 minutes
for the heater plate and water to cool.
2. Open the humidifier door, and then slide the water tank out of the humidifier base. Empty any
remaining water.
3. Push the tank slider to the right, and then gently pull apart the top and bottom halves of the
humidifier tank by pulling upward on the tank tabs or tank inlet/outlet.
fIgure 12: separaTIng The WaTer TanK for CleanIng
4. Wash all parts using one of the following methods:
a. Place on the top rack of the dishwasher. Rinse the parts with clean water and allow
them to air dry.
b. Wash in a solution of warm water and a mild dishwashing detergent. Rinse the
parts with clean water and allow them to air dry.
tank slider
top seal
tank inlet/outlet
tank tabs