User manual

0 M Series Heated Humidier
daIly use
1. Place the humidifier platform on a firm, flat surface lower than your sleeping position.
NOTE: Take appropriate precautions to protect furniture from water damage.
CAUTION: Do not turn the humidier on without the water tank installed.
WARNING! Allow the humidier heater plate and water to cool down for
approximately 15 minutes before removing the water tank. A burn may
result from touching the heater plate, coming in contact with the heated
water, or touching the tank pan.
2. Lift the humidifier door and remove the water tank by sliding it out of the humidifier base.
fIgure 4: reMovIng The WaTer TanK
3. Rinse the tank with water. Fill the tank to the fill line with room temperature distilled water
(approximately 1-2/3 cups or 325 ml).
CAUTION: Use only distilled water in the tank.
fIgure 5: fIllIng The WaTer TanK
CAUTION: Fill the humidier with room temperature water only. Filling the humidier
with water that is too cold or too hot may cause errors in the humidier,
causing the blue LED to blink.
CAUTION: Do not overll the water tank. Damage to the humidier or therapy device
may occur.