User manual

6-2 BIpap auto m SerIeS uSer manual
6.2 uSIng the SmartCard
Some BiPAP Auto M Series systems come with a SmartCard accessory module installed in the
accessory slot on the back of the device to record information for the home care provider. Your
home care provider may ask you to periodically remove the SmartCard and send it to him/her for
evaluation.
Note: The SmartCard does not need to be installed for the device to work properly.
The SmartCard records device usage information for use by your home care
provider. Contact your provider if you have any questions about the SmartCard.
6.3 addIng Supplemental oxygen
Oxygen may be added at the mask connection. Please note the warnings listed below when using
oxygen with the device.
WarnIngS
• When using oxygen with this system, the oxygen supply must comply with local regulations
for medical oxygen.
• When using oxygen with this system, a Respironics Pressure Valve (Part number 302418)
must be placed in-line with the patient circuit. Failure to use the pressure valve could result
in a fire hazard.
• Oxygen accelerates fires. Keep the device and the oxygen container away from heat, open
flames, any oily substance, or other sources of ignition. Do not smoke in the area near the
device or the oxygen.
• When using oxygen with this system, turn the device on before turning on the oxygen. Turn
the oxygen off before turning the device off. is will prevent oxygen accumulation in the
device.
• If administering fixed-flow supplemental oxygen, the oxygen concentration may not
be constant. e inspired oxygen concentration will vary, depending on the IPAP and
EPAP settings, patient breathing pattern, and leak rate. Substantial leaks around the mask
may reduce the inspired oxygen concentration to less than the expected concentrations.
Appropriate patient monitoring should be implemented.