User manual

4-10 BIpap auto m SerIeS uSer manual
To answer the FOSQ questionnaire, complete the following steps:
1. Make sure that the SmartCard or modem is properly installed. Answers to the questionnaire
are saved onto the SmartCard or sent to the health care professional via a wired or wireless
modem (when available). If you are using a SmartCard, a SmartCard symbol ( )
appears in the upper right corner of the Active Display screen. If the SmartCard is inserted
incorrectly, this symbol flashes to indicate that the card is incorrectly installed, and the
FOSQ questionnaire will not be available.
2. From the Standby screen, press the – button to first FOSQ screen, shown in Figure 4–9.
FOSQ 1/30
0 1 2 3 4
fIgure 4–9 foSQ SCreen 1 of 30
Press the + or – button to select your answer to the first question, and an arrow appears over
your answer:
– 0 indicates that you choose 0 as the answer to the question.
– 1 indicates that you choose 1 as the answer to the question.
– 2 indicates that you choose 2 as the answer.
– 3 indicates that you choose 3 as the answer.
– 4 indicates that you choose 4 as the answer.
3. After you answer the first question, press the button to access the next FOSQ screen and
continue answering each question. If you need to go back to a previous screen, press the
button.
4. ere are 30 FOSQ questions. Once you have reached the last question, press the button
to save your answers and exit the questionnaire.
4.6 patIent remInder SCreen
Your home care provider may set a patient reminder that will appear periodically to alert you
to take certain actions, such as replacing your mask. A message will appear whenever the device
transitions from the Active Display to the Standby state if the period of time specified by your
provider has expired.
You can acknowledge the message by pressing any of the display buttons (+, –, or ). If you
do not acknowledge the message within six minutes of it appearing on the screen, it will time
out and disappear. e message will continue to display for three consecutive days whenever the
device transitions from Active to Standby until it is acknowledged. If, after three days, you still
have not acknowledged the message, then the reminder period will reset and no more reminders
will display until the next time the patient reminder setting expires.
Figure 4–10 shows an example of a patient reminder message.
Patient Reminder
Check your mask, a
new one may be
available. Call your
provider.
fIgure 4–10 patIent remInder SCreen