User manual

4-4 BIpap auto m SerIeS uSer manual
4.3.2.2 BI-flex loCKed
Your provider may enable Bi-Flex, but lock the setting so you cannot adjust the level. If Bi-Flex is
locked, a screen similiar to the one shown in Figure 4-5 appears.
1 2 3
Bi-Flex Setting
fIgure 4–5 BI-flex loCKed SCreen
e arrow appears above the setting the provider has prescribed for you, and a lock symbol
displays to indicate that you cannot adjust the setting.
4.3.2.3 BI-flex dISaBled
If Bi-Flex has not been prescribed for you and your provider has disabled the Bi-Flex feature, the following
screen appears when you press the Bi-Flex button, and you cannot enable or adjust the setting.
FLEX comfort has been
disabled on this unit.
Bi-Flex Setting
fIgure 4–6 BI-flex dISaBled SCreen
4.4 ChangIng the devICe SettIngS
You can view the set pressure on the Active Display screen, and you can view the following
settings on the Patient Data screens:
• erapy usage hours
• Number of sessions greater than 4 hours
• 90% therapy pressure averages – only appears in Auto Bi-level therapy (if enabled by your
home care provider)
• System leak (if enabled by your home care provider)
• Apnea/Hypopnea Index (if enabled by your home care provider)
• Compliance check value
• Summary Data
Additionally, you can view and modify the following settings on the Patient Setup screens:
• Bi-Flex (if enabled by your home care provider)
• Ramp starting pressure (if enabled by your home care provider)
• Mask alert (enable/disable)
• Auto off (enable/disable)
• FOSQ questionnaire