User manual

2-1BIpap auto m SerIeS uSer manual
Chapter 2: devICe ControlS and dISplayS
is chapter describes the device’s control buttons and displays, patient circuit connections, and
rear panel connections.
2.1 ControlS and dISplayS
Figure 2–1 shows the three primary control buttons on the BiPAP Auto M Series device.
Bi-Flex
fIgure 2–1 prImary Control ButtonS
ese buttons are described below.
Button deSCrIptIon
Ramp – When the airow is on, this button allows you to activate or
restart the ramp function. Ramp lowers the airow pressure and then
gradually increases it, allowing you to fall asleep more easily.
Start/Stop – This button starts the device’s airow and places the
device in the Active state, or stops the airow, and places the device in
Standby. You can also press this button to exit any setting screen.
Bi-Flex Bi-Flex – This button adjusts the Bi-Flex comfort setting.
If you do not want to modify the settings that your home care provider has set for you, you only
need these three buttons to start and stop therapy and do not need to use the display buttons located
under the device cover door.
Figure 2–2 shows the device display and navigation buttons that are under the cover door.
– FOSQ
+
Setup
fIgure 2–2 dISplay ButtonS
e display buttons are described below:
Button deSCrIptIon
Allows you to access the Data screens. Also allows you to navigate to
the previous screen when in the Data or Setup menu.
Allows you to access the Data screens. Also allows you to navigate to
the next screen when in the Data or Setup menu.
Allows you to enter the FOSQ screens. Also allows you to decrease the
settings on the setup screens.
Allows you to enter the Setup screens. Also allows you to increase the
settings on the setup screens.