Specifications

11
EverGo User Manual
Note: An optional EverGo Smart Battery Charger/Recalibrator
(sold separately) is available for your system. For more information,
contact your home care provider or see the Respironics EverGo web
site at www.evergo.respironics.com
operaTInG The everGo devICe
Warning: Do not use the device without at least one battery installed and
operating.
• To run the device on battery power, make sure one or both batteries
are properly inserted and sufficiently charged. (e batteries should
be fully charged the first time you use them.)
• To run the device using AC power, make sure you have at least one
battery installed. Follow these steps:
1. Connect the output cable of the AC Power Supply to the
EverGo power inlet.
2. Connect the connector of the AC Power Cord into the AC
power supply.
3. Connect the plug of the AC Power Cord into an AC outlet
installed to meet national or regional electrical code.
Note: e AC Power Supply is equipped with a green light, which
illuminates when it is connected to an energized AC power source.
• To run the device using DC power from an automobile or other
motorized vehicle, make sure you have at least one battery installed.
Start the vehicle and connect one end of the DC Power Cord to
the device’s power inlet and the other end into the vehicle’s DC
electrical outlet.
Back Up Breathing
When you turn on your EverGo device, it will sense if you are breathing
from it. If you are not yet breathing through the cannula, EverGo will begin
to pulse automatically about once every five seconds. e only purpose of
this “back up breathing” is to help the unit warm up faster. As soon as you
begin breathing through the cannula, the device will begin delivering pulses
based on your breathing. Back up breathing occurs only when you first turn
on the device. You may begin breathing from the EverGo at any time.