Specifications

10
EverGo User Manual
Charging the Batteries with AC Power Supply
Important: e first time you charge the batteries, be sure to charge them
fully. Do not use the DC power cord to do so; instead use AC power.
Note: e batteries will begin charging whenever you connect the device to
an AC outlet, even if you’re using it.
To charge the batteries using the AC Power Cord provided with your
system, follow these steps.
1. Connect the output cable of the AC Power Supply to the EverGo
power inlet.
2. Connect the connector of the AC Power Cord into the AC power
supply.
3. Connect the plug of the AC Power Cord into an AC outlet installed
to meet national or regional electrical code.
Figure 6. Connecting the power cord to the connector located under the Velcro flap.
A typical battery charging screen is shown on the right
Note: As soon as you connect the device to an energized AC power
source, the light on the AC Power Supply will light up and the
cooling fan will come on. is is normal. e fan will run the
entire time it is charging to keep the batteries cool.
4. When charging is complete (this takes a minimum of four hours
for first use), disconnect the AC Power Supply and store it with the
AC Power Cord for future use.
Note: Replacement and spare batteries are available separately. For
information, contact your home care provider or see the EverGo web
site at www.evergo.respironics.com