Specifications

9
EverGo User Manual
4. Gently insert both batteries
into the battery compartments
located on top of the device.
Before inserting each battery, be
certain that the battery connector
on the bottom of the battery
lines up with the arrow located
next to the battery slot and the
Respironics logo faces the inside
of the device. Pull back the plastic
retainer to allow the battery to fit
properly.
5. You may remove or insert your
secondary battery using the small
flap on the top of the carrying
case to gain access to the battery
compartment, shown here. Refer to
the diagram under the flap which
shows how the battery is inserted.
Again, the Respironics logo
should face the inside of the device.
6. After the batteries are inserted, check to make sure each one is
level with or slightly below the top of the plastic case. When fully
inserted, the plastic retainer tab holds the battery in place. If either
battery extends above the top gray surface, it may be in backwards.
Remove it and insert it correctly. Do not force the battery.
7. Zip the case closed and keep
it zipped during use.
8. Touch the screen once
to verify that the battery
symbols are visible. If you do
not see battery symbols, one
or both batteries have been
inserted correctly. Reinsert
them if necessary.
Figure 3. Inserting the primary
battery.
Figure 5. Typical startup screen showing
2 batteries, each 3/4 full and with 421 hours of
device usage.
Figure 4. Inserting the secondary
battery.