Specifications

8
EverGo User Manual
Inserting the Batteries
Your EverGo device comes with two lithium ion batteries. To insert them
correctly, follow these steps.
1. Place your device in a well ventilated location.
Note: e EverGo device is shipped from the factory with both
batteries removed.
Caution: Open the carrying case only when EverGo is turned off.
Never open the case while the unit is operating.
2. Open the top of the carrying case using the zipper located
underneath the flap
surrounding the top part
of the case, as shown here.
If the device has been
operating, the surfaces
inside may be warm to the
touch.
is is normal.
.
3. Check the fuel gauge for
each battery. To do so, press the PUSH button on the battery and
watch how many LEDs light up. If the batteries are low, you can
recharge them. See page 11.
No� of LEDs Battery Charge
4 LEDs Light:
75% to 100% full
3 LEDs Light:
50% to 75% full
2 LEDs Light:
25% to 50% full
1 LED Lights:
10% to 25% full
1 LED Blinks
3 Times:
Battery is less than
10% full and
needs to be
recharged
PUSH
Figure 2. Battery Fuel Gauge
Figure 1. Opening the carrying case
Table 2. Battery Charge Level