User manual

Provider Manual

NOTE: If the display backlight is off, the first press of any key turns

the backlight on. Normal key function is suppressed until the

key is pressed a second time.

NOTE: When changing any setting (except for the Ramp Start Pres-

sure setting), once a maximum setting is reached, the setting

rolls back over to the minimum setting, and likewise, once a

minimum setting is reached, it rolls back over to the maxi-

mum setting provided.

For example, the minimum Flex setting is 1 and the maximum

is 3. Once the Flex setting is increased to 3, if you press the

Heat key again, the setting will go back at 1. Or, once the Flex

setting is decreased to 1, if you press the Ramp key again, the

setting will go back to 3.

6.2.1 CHANGING THE HUMIDIFIER SETTING

If you are using an optional REMstar or H2 heated humidifier with your

Harmony, you can adjust the humidifier heat setting by completing the

following steps:

1. From either the Standby or Monitoring screen, press and hold the

Heat key for approximately 4 seconds. The Humidifier Setting screen

appears, as shown in Figure 6–6.

Figure 6–6 Humidifier Setting Screen

2. Press the Heat key to increase the humidifier setting, or press the

Ramp key to decrease the setting. You can adjust the setting from 1

to 5. The change takes effect immediately as you adjust the setting.

For additional information on using a humidifier wit the Harmony,

see Chapter 9.