User manual

Provider Manual

Figure 5–2 Attaching the Filter Cap

NOTE: The filter cap should be installed with the air inlet opening at

the bottom.

See Chapter 8 to clean or replace the filters.

5.2 WHERE TO PLACE THE HARMONY

Place the Harmony on its base somewhere within easy reach of where

you will use it. Make sure that the air inlet on the rear of the unit is not

blocked. Place the unit on a hard, flat surface. If you block the air flow

around the unit, the Harmony may not work properly.

If you are using a humidifier, place the humidifier and unit on a

placemat or other waterproof material to protect your furniture from

moisture. Position the humidifier so the water level is lower than you

and the humidifier is on the same level or lower than the Harmony. See

the humidifier instructions for complete setup information.

5.3 CONNECTING THE BREATHING CIRCUIT

To connect your breathing circuit to the Harmony, complete the follow-

ing steps:

1. Connect one end of the circuit tubing to the outlet of the bacteria

filter (if using one) and connect the inlet of the bacteria filter to the

large connector on the Harmony as shown in Figure 5–3.

If you are not using a bacteria filter, connect the end of the circuit

tubing directly to the outlet connector on the Harmony.