Specifications

26
1a. See Figure 27. Use a standard screwdriver to pry the fuse holder out of the retainer.
2a. Grasp the exposed sides of the fuse holder and pull it completely out of the unit.
3a. Replace the old fuses with new fuses of the same type and rating.
4a. See Figure 28. Push the fuse holder back into the unit until it snaps into place.
Figure 27
Figure 28
Changing the Unit Fuses
If the unit is not operational when you turn it on, the fuses may need to be replaced.
The fuses are located in the back of the unit under the power cord connector. See page 13 for fuse ratings.
You may have one of two types of fuse holders. If the fuse holder has tabs on either side, as shown in
Figure 25, follow Steps 1 to 4 to replace the fuses. If the fuse holder has a tab on top, as shown in Figure
27, follow Steps 1a to 4a to change the fuses.
1. See Figure 25. Remove the fuse holder by pinching in on the small tabs on the sides of the holder.
2. Pull the fuse holder completely out of the unit.
3. Replace the old fuses with new fuses of the same type and rating.
4. See Figure 26. Push the fuse holder back into the unit until it snaps into place.
Routine Maintenance
Figure 25
Figure 26