User manual

43
User Manual
5. Ifneeded,washthegrayfoamlterinwarmwaterandamild
detergent.Rinsethelterthoroughlytoremovealldetergentresidue.
Allowtheltertocompletelydrybeforereinstallingit.Ifthepollen
lteristorn,replaceit.
6. Iftheultra-nelterisdirtyortorn,replaceit.
7. Reinstallthelters,withtheultra-nelteronthebottom.Slidethe
ltersintotheairinletattherearofthedeviceandpushthemdown
into the recess.
8. Replacetheltercap.
Contactyourhomecareprovidertoorderadditionallters.
NOTE: To clean the breathing circuit accessories, refer to each
accessory’s instruction sheet.
9.3 Ca r r y i n g Ca s e
A carrying case is now included with your BiPAP S/T system (reorder
number: 1005965). The case is designed to hold your BiPAP S/T system,
alongwithyourbreathingcircuitaccessoriesandhumidier.
Whenyouaretraveling,thecarryingcasecanbeusedforcarry-on
luggage only. The carrying case will not protect the device if it is put
through checked baggage.
NOTE: Iftravelingwithyourhumidier,makesureyouemptythe
water chamber before placing it in the carrying case.