User manual

41
User Manual
Ch a p T e r 9: Cl e a n i n g a n d ma i n T e n a n C e
This chapter provides information on how to clean and maintain your
BiPAP S/T system.
9.1 Cl e a n i n g T h e de v i C e
Before cleaning or performing any routine maintenance, always make
sure the unit is not operating and disconnect the device from the power
source.
NOTE: The following cleaning instructions are for the BiPAP S/T
unit only. To clean the accessories, refer to each accessory’s
instruction sheet.
CAUTION: Do not immerse the unit or allow any liquid to enter the
enclosure,inletlter,oranyopenings.
Clean the front panel and exterior of the enclosure as needed using a
cloth dampened with water and a mild detergent. Allow the device to
dry completely before plugging in the power cord.
Gently wash the reusable circuit tubing in a solution of warm water and
a mild detergent. Rinse thoroughly and allow to air dry.
9.2 Cl e a n i n g o r re p l a C i n g T h e in l e T fi l T e r s
Thedevicehastworemovableltersattheairinlet.Thegrayfoam
lteriswashableandreusable.Theoptionalwhite,ultra-nelteris
disposable.Thegrayfoamltershouldbecleanedatleastonceevery
two weeks under normal usage and replaced with a new one every six
months.Thewhiteultra-nelterisdisposableandshouldbereplaced
after 30 nights of use or sooner if it appears dirty. Do not attempt to clean
theultra-nelter.Itwilldamagethelter.
NOTE: Dirtyinletltersmaycausehighoperatingtemperaturesand
mayaffectperformance.Regularlyexaminetheinletltersas
needed for integrity and cleanliness.