User manual
30
User Manual
To change the rise time setting, complete the following steps:
1. From either the Monitoring or Standby screens, press the Right User
button until you reach this screen. The Rise Time Setting screen is
shown in Figure 6–9.
Figure 6–9 Rise Time Setting Screen
2. Increase or decrease the rise time setting from 1 to 6 by pressing the
Heat or Ramp buttonuntilyoundtherightsetting.Asettingof1 is
the fastest rise time, while 6 is the slowest.
6.2.2.3 Ch a n g i n g T h e ra m p sT a r T i n g pr e s s u r e
The device is equipped with an optional ramp feature. This feature will
reduce the pressure and then gradually increase (ramp) the pressure to
the prescription pressure setting so you can fall asleep more comfortably.
NOTE: The ramp feature is not prescribed for all users. If the screen
shown in Figure 6–10 does not appear on your display, you
cannot adjust this setting.
To change the ramp starting pressure setting, complete the following steps:
1. From either the Monitoring or Standby screens, press the Right User
button until the Ramp Start Setting screen appears, as shown in
Figure 6–10.
Figure 6–10 Ramp Start Setting Screen
2. Press the Heat or Ramp button to increase or decrease the ramp
starting pressure as needed. You can adjust the setting from 4.0 cm
H
2
O to your EPAP or CPAP setting.