User manual

27
User Manual
6.2.1 Ch a n g i n g T h e hu m i d i f i e r se T T i n g
IfyouareusingtheREMstarHeatedHumidierwithyourBiPAPS/T,
youcanadjustthehumidierheatsettingbycompletingthefollowing
steps:
1. From either the Standby or Monitoring screen, press and hold the
Heat buttonforapproximately4seconds.TheHumidierSetting
screen appears, as shown in Figure 6–6.
Figure 6–6 Humidier Setting Screen
2. Press the Heat buttontoincreasethehumidiersetting,orpressthe
Ramp button to decrease the setting. You can adjust the setting from
1 to 5. The change takes effect immediately as you adjust the setting.
3. You can exit this screen by pressing the Left or Right User buttons or
the Silence button.
 Foradditionalinformationonusingahumidierwiththedevice,see
Chapter 10.
6.2.2 na v i g a T i n g T h e us e r di s p l a y sC r e e n s
You can navigate the rest of the user display screens by pressing the Left
and Right User buttons.
You can change the settings on any of the display screens by pressing the
Heat and Ramp buttons to increase or decrease the setting.
You can exit any of the user display screens by pressing the Silence
button.