User manual
22
User Manual
5.5.1 us i n g aC po W e r
Complete the following steps to operate the device using AC power:
1. Plug the pronged end of the AC power supply’s cord into an
electrical outlet.
2. The external AC power supply features a cord retainer to provide
strainrelieffortheACpowercord.WrapthecordaroundtheAC
power supply’s cord retainer, using the wire tie supplied with your
power supply.
WARNING: Never plug the AC power supply into an outlet that is
controlled by a wall switch.
WARNING: Route the wires to avoid tripping.
3. Leaving a small amount of slack in the cord, connect the cord on
the other side of the power supply to one of the power inlets on
the device, as shown in Figure 5–8. The power cord has a locking
connector. To properly plug the cord in:
a. Pull the locking mechanism back.
b. Push the connector into place.
c. Release the lock.
Figure 5–8 Plugging in the AC Power Supply