User manual

18
User Manual
3. AttachtheltercapasshowninFigure5–2.Positionthecapsothat
the small opening on the cap is facing down. Insert the caps bottom
tabsintotheopeningsbelowthelterarea.Snapthecapintoplace.
Figure 5–2 Attaching the Filter Cap
NOTE: Theltercapshouldbeinstalledwiththeairinletopeningat
the bottom.
SeeChapter9tocleanorreplacethelters.
5.2 Wh e r e T o pl a C e T h e bipap s/T
Place the device on its base somewhere within easy reach of where
you will use it. Make sure that the air inlet on the rear of the unit is not
blocked.Placetheunitonahard,atsurface.Ifyoublocktheairow
around the unit, the device may not work properly.
WARNING: Positionthehumidiersothewaterlevelislowerthan
you,andthehumidierisonthesamelevelorlowerthan
thedevice.Seethehumidierinstructionsforcomplete
setup information.