User manual

User Manual
23
1. From either the Monitoring or Standby screens, press the Right User button until the LED Backlight
Setting screen appears, as shown in Figure 6–10.
LIGHT
Figure 6–10 LED Backlight Setting Screen
2. Press the HEAT or RAMP button to select a new setting. A setting of 1 means the light is on, while 0
means the light is off.
6.3 monitoring measured Parameters
You can view four measured parameters—leak, respiratory rate, minute ventilation, and exhaled tidal
volume. To access these screens from the Monitoring or Standby screens, press the small circular Scroll
button (
SILENCE
SILENC
E
) located near the RESET button.
Figure 6–11 shows how to navigate the measured parameter screens.
Scroll
Button
Scroll
Button
Scroll
Button
Scroll
Button
Leak Screen
Respiratory Rate Screen
Minute Ventilation Screen
Exhaled Tidal Volume Screen
LEAK
Figure 6–11 Measured Parameter Screen Navigation
To return to the Monitoring or Standby Screen from these Measured Parameter screens, press the
SILENCE button.
NOTE: If you view these screens from the Standby screen, each of these screens will display a value of
zero, because no therapy is being delivered.