User manual

User Manual
23
6.2.2.1 CHANGING THE FLEX SETTING
 e Flex screen is displayed only if it is prescribed. If the Flex feature is enabled, you can adjust the Flex
setting to fi nd the setting that provides you with the most comfort.
If the screen shown in Figure 6–8 does not display, you cannot adjust this setting.
Change the Flex setting by completing the following:
FLEX
Figure 6–8 Flex Setting Screen
1. From either the Monitoring or Standby screens, press the Right User button until you reach this screen.
2. Increase or decrease the FLEX setting by pressing the HEAT or RAMP button s until the correct
setting appears. You can adjust the pressure from 1 to 3 in increments of 1.
6.2.2.2 CHANGING THE RISE TIME SETTING
Rise time is the time it takes for the device to change from EPAP to IPAP. When enabled, you can adjust
the rise time to fi nd the setting that provides you with the most comfort.
If the Rise Time Setting screen shown in Figure 6–9 does not display, you cannot adjust this setting.
Change the Rise Time setting by completing the following steps:
RISE TIME
Figure 6–9 Rise Time Setting Screen
1. From either the Monitoring or Standby screens, press the Right User button until you reach this screen.
2. Increase or decrease the rise time setting from 1 to 6 by pressing the HEAT or RAMP button until
you fi nd the right setting. A setting of 1 is the fastest rise time, while 6 is the slowest.