Service manual

3.Setting the Operation Time
Press the "TIMER" Button to select the time
for operation. Each time it is pressed the timer
setting switches as shown below:
"1hr"-"2hr"-"3hr"----"11hr"-"12hr"
English
E-9
E-16
IMPORTANT SAFETY PRECAUTIONS
This manual classifies precautions into WARNINGS and CAUTIONS. Be sure to
to follow all precautions below: They are important for ensuring your safety.
If you do not follow these instructions
exactly, the unit may cause minor
property damage or personal injury.
WARNING
If you do not follow these instructions
exactly, the unit may cause property
damage, personal injury or loss of life.
CAUTION
Do not use the power cord if it is damaged or
loose in the socket. Using the power cord in
anything but proper working condition can lead
to short-circuits and subsequently electric shock
and/or fire.
Do not do anything that could damage the
electrical power cord. Do not set heavy items on
the cord or place the cord between items. If the
electrical power cord is damaged, fire or electric
shock may occur.
Use the plug provided exclusively for the product.
Connecting the system in an improper power
source may cause electric shock or a breakdown
of the system.
If the power plug is unplugged,be sure to hold and
pull out the end of the power plug without holding
the power cord. Do not pull on the power cord to
remove the plug from the wall outlet. There is a
chance that an electrical shock or short- circuit
may occur causing a fire.
OPERATION
Main Unit Operation
2.Manually Switch the Airflow
Rate
Each time the Speed button is
pressed the airflow rate changes
as shown below:
L(Low)------M(Medium)------
H(High)-----L(Low)... ...
5.Press Auto button
The fan speed is automatically
switched(HIGH, MEDIUM, LOW)
depending on the amount of
pollution in the air. The Gas and
Dust sensor detects the pollution
and automatically sets the fan
speed for efficient air purification.
NOTE: When the set time is reached, the
operation will automatically stop. The set
time can be changed if the button is pressed
while the unit is operating.
120V
hr
Check Unit
Negtive Ion
Timer
Swing
Night
L
M
H
L-R
Filter Life
UV Lamps
Speed
Auto
Gas Level
Dust Level
Power
Speed Timer Swing Auto
Power Speed Timer Swing Auto
Connect the Power
When the power plug is inserted into the wall outlet all the indicators on the display panel will light up for 2
seconds.(As shown in the diagram below)
1.Operate the Unit
Press the Power(On/Off) button
to start operating the unit.Press
the button again will stop
operation.
NOTE:When the power is
connected, the "Gas Level" and
"Dust Level" indicator lights will
flash for 3 minutes.
4.Press Swing Button
When the Swing button
is pressed, the louver of
the unit will swing
horizontally.Pressing the
button again will stop
swing.
(Cancel)