Service manual

ENGLISH
E-21
E-4
FOR CUSTOMER ASSISTANCE CARE AND MAINTENANCE
If you have questions about your air purifier, call the customer service number. Before calling, please note the
model and serial number located on the back of the unit and fill in the following information below. This information
will help us answer your questions much more quickly.
Model number
Serial number
Date of purchase
Dealer name
Address
City
Province
Postal code
Telephone
Phone:[phone]
Write:For service problems, warranty information, missing items
and other assitance:
RepirAide Tech Inc.
13-100 Hanlan Road Woodbridge, Ontario Canada
L4L 4V8
Please provide the following information when you write or
call:model number, serial number, date of purchase, your
complete mailing address(including Postal Code), your daytime
telephone number(including area code) and description of the
problem.
Replacing the Activated Carbon Filter
When the "Filter Life" indicator light flashes in yellow, you
have 50 hours of operation remaining.
1) Stop the operation and unplug the cord from the
electrical outlet.
2) Open the front panel.
3) After removing the cell, pull out the Activated Carbon
Filter.
Photo catalyst & UV Germicidal Lamp
Germicidal Light Radiation
Hazard
Never look directly at UV lamp or
place face directly on outlet grill.
Direct exposure to germicidal light
can cause temporary or chronic
damage to your eyesight, or even
blindness.
Always unplug the unit before
cleaning, servicing or replacing the
UV lamp.
WARNING
Photo catalytic filter is permanent, never needs
replacing.
When there is dust on it, clean the dust off using a
vacuum cleaner dusting brush. Do not wash it in
water.
When the "UV Lamps" indicator light flashes, it is time
to replace the Ultraviolet germicidal lamp. Gently
rotate the lamp a quarter turn in either direction until it
unlocks from the socket. Pull the pins out the sides of
the socket, one end at a time.
NOTE:
1)Do not wash the photo catalyst filter in water.
2)Do not look at the UV lamp when it is lit, it can cause
personal injury.
1.
2.
After replacement of Activated Carbon filter or UV lamp, be sure to press Filter
Reset Button(RESET1 Button) or UV Lamp Reset Button(RESET2 Button) on
the remote control for 12 times. Once the Reset Buttons have been activated,
you will hear a beep sound that means that the unit has been reset and the
Filter Life or UV Lamp indicator lights will stop flashing.
CAUTION
Photo catalytic Filter
UV Germicidal Lamp
Replacing UV lamp
Replacing
the Carbon Filter
R