Service manual

ENGLISH
E-15
E-10
IMPORTANT SAFETY PRECAUTIONS
Do not place the product in direct contact with
sunlight. It may cause malfunction and
deformation of the product.
Do not block the intake or outlet. Blocked
openings can reduce capacity or damage the
unit.
If any parts of the power source get wet remove
the plug and dry it completely before reusing.
Use the product in the ambient temperature of
0-40C.
Do not operate the unit or touch the plug with
wet hands. It may cause electric shock.
Use a fuse with proper capacity. Never use a
wire in place of a fuse. Doing this may lead to
malfunction or fire.
BEFORE OPERATION
Remote Control Setup
Preparing the remote control
The battery is already set in the remote control, pull out the clear sheet from the battery cover
before using.
How to use the remote control
a) Point the transmitter of the remote control towards the receiver of the main unit. If an
obstruction to the signal exists, the remote control will not operate.
b) The distance from which the remote control can transmit is approximately 19 feet(6m).
+
Battery Information
1.Open the cover on the rear of the remote control towards the arrow.
2.Replace the battery with CR2025 battery. Be sure to set the battery with the+ side up.
3.Close the cover to its original position.
4.The battery for this remote control is for initial use only. Change the battery when necessary.
5.When not using the unit or remote control for an extended period, remove the battery.
6.Store the battery where babies and children can not reach them. If the battery is
swallowed contact a doctor immediately.
7.When discarding battery, cover the terminals of the battery with tape. If mixed with other metal or
batteries, heat, explosion or combustion may occur.
8.Bring the battery to a nearby electronics store, watch store or camera store to recycle them.
CR2025 Battery
Remote Control
1.Do not drop or place the remote control in water. (Damage may occur.)
2.Do not press the remote control buttons with sharp objects. (Damage may occur.)
3.The remote's signal may not be received properly if fluorescent lamps (such as inverter
fluorescent lamps) are in the same room.
Copper Wire
125V 2A
5 C
40C
Relative humidity<80%
Power Night
Speed
Swing Auto
UV Lamp Neg.Ion
RESET1 RESET2
Timer