Installation guide

Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Revision 2.7 Page 5 of 83
Mercury Plant Controller Installation Guide
Front Panel: -
Section 1 Display
4 character display, shows the pressure (suction for pack, discharge for condensers)
In set-up mode, displays the set-up menu items
In quick view mode, indicates the target pressure
In Override mode, indicates and allows the relays to be forced on
Section 2 Display
4 character display, shows the pressure (suction for pack, discharge for condensers)
In set-up mode, display is blank
In Override mode, display is blank
Front Panel Buttons
Enter Button: - Used to enter menu items.
Up Button: - Used to scroll up
Down Button: - Used to scroll down
Quick View Button: - Used to view the target pressure (See Quickview section)
Override Button: - Used with the "Enter" button, to go into the override mode. (See Override section)
Info Button: - Used to view the current analogue outputs values. (See Info section)
FLT 1
FLT 2
PRESSURE
1
PRESSURE
2
Resource Data Management
Section 1
Display
Section 2
Display
FLT1
System Alarms
FLT2
Status Alarms
Enter
button
Up
button
Down
button
Quick view
button
Override
button
Info
button